![\"water](\"http:\/\/www.wickedvan.eu\/wp-content\/uploads\/2009\/05\/dscf5758.jpg\" "\\"dscf5758\\"")
<\/a>water inlet<\/p><\/div>\n
this is the water inlet for the fresh water tanks. therefore i cut into the wall and reinforced the sheet metal with a wooden frame.<\/p>\n
<\/a>isolation<\/p><\/div>\n
the next step was to isolate the outer wall<\/p>\n
<\/a>tank fitting<\/p><\/div>\n
to fit the fresh water tanks i will use two tension belts. therefore i screwed the ratched spanners directly to the bottom.<\/p>\n
<\/a>measurements<\/p><\/div>\n
to install the first wall i had to measure everything correctly. i used the support on the left side as a reference.<\/p>\n
<\/a>angle bracket<\/p><\/div>\n
to connect the wall to the car i first used aluminum brackets with glue (sikaflex 252). the next day i realized that the glue does not stick to the aluminum oxide surface. so i removed the brackets and replaced them by brackets made out of steel. later on i still used aluminum brackets with sikaflex but i scratched the surface to remove the oxide and stamp some pattern on it. the glue is enough to connect the wall, there is no need to fix it with screws.<\/p>\n